Referee Mag Article-BU Inside Infield w/ Runner on 3rd Only

[jwwashburn]

Originally Posted by IRISHMAFIA

Becoming a target in the biggest hole in an infield, getting turned around on a ball up the middle (BU always has 1st play in the infield),

As soon as I can find this article, I will post it for everyone to see. I cannot see any reason why I the BU would get "turned around".

ending up in the middle of a play,

Not if you are paying attention.

being hit by a batted ball prior to it passing a fielder,

I work both baseball and softball...I have not been hit in baseball(even at the U13/14 level where the pitching plate is a lot closer) and the baseball can and does come at you a lot harder.

not being in a position to go out on a possible catch/no catch scenario are a few that come to mind.

I have not seen a mechanic that allows for the BU to go out with runners on. However, my position(behind the pitching circle) wouldput me in a MUCH better position for helping on a catch/no catch scenario as I could help in more of the outfield.

As for the play at first, you have to admit that your view would be better. The snap throw back to third? Better angle, as well. There ARE posiitives to this position-there may be negatives, as well...but most of the ones that I hear don't seem to be very well thought out.

Your pal,

Joe In Michigan

[mcrowder]

Originally Posted by jwwashburn

As soon as I can find this article, I will post it for everyone to see. I cannot see any reason why I the BU would get "turned around".

If the fielders are playing at normal depth, then they are farther from the plate than you. So you either have your back to first base, or your back to the fielder. There is no way too keep both of them in your vision. So you are turning one way to watch the fielding of the ball, moving backward toward first base to get closer, and then turning 180 degrees as the ball is thrown to watch the play at first.

Originally Posted by jwwashburn

[Not if you are paying attention.

Pay attention all you want. You are still "in the middle of things" if ball is hit to shortstop, and in the way if the ball is hit up the middle - having to dodge before getting yourself into position.

Originally Posted by jwwashburn

[I work both baseball and softball...I have not been hit in baseball(even at the U13/14 level where the pitching plate is a lot closer) and the baseball can and does come at you a lot harder.

So do I. Perhaps you noticed the difference in the size of the diamonds? THIS is the reason that being inside is normally a bad mechanic in softball, but can be workable in baseball. You might notice that in your baseball mechanics manuals, they do not recommend working inside on a 60' baseball diamond either. Same reasons as softball.

Originally Posted by jwwashburn

[I have not seen a mechanic that allows for the BU to go out with runners on. However, my position(behind the pitching circle) wouldput me in a MUCH better position for helping on a catch/no catch scenario as I could help in more of the outfield.

As for the play at first, you have to admit that your view would be better. The snap throw back to third? Better angle, as well. There ARE posiitives to this position-there may be negatives, as well...but most of the ones that I hear don't seem to be very well thought out.

Yes, there are positives. But the negatives outweigh them, and are very real if you've tried this in a game of significant level. I suggest you work a scrimmage or three with this mechanic (at a level higher than 10U) and you'll probably find you agree with Mike and I.

[AtlUmpSteve]

Originally Posted by mcrowder

Yes, there are positives. But the negatives outweigh them, and are very real if you've tried this in a game of significant level. I suggest you work a scrimmage or three with this mechanic (at a level higher than 10U) and you'll probably find you agree with Mike and I.

This is one of those threads were someone has decided his way is better, and has only asked the question to get corroboration, not to listen to the answers. I bet he keeps using his way, because he is sure he knows more than generations of baseball and softball umpires about working inside a 60' diamond.

[BuggBob]

The mechanic for two umpires in slow [itch USSSA put the BU inside, but our UIC for slow pitch USSSA had us move to the outside because of the danger of being creamed by the batted ball, interfering with the throw from short, and being too close to a play at second. When we were inside you would actually hide behind the pitcher and get as close to second as possible (further from the batted ball). With runners on 2nd you would block their view of the pitch and hit and even possibly be in their way when they would run. I think inside works in baseball, but not in softball.

Bugg

[jwwashburn]

Originally Posted by AtlUmpSteve

This is one of those threads were someone has decided his way is better, and has only asked the question to get corroboration, not to listen to the answers. I bet he keeps using his way, because he is sure he knows more than generations of baseball and softball umpires about working inside a 60' diamond.

What a giant leap you are taking, there Steve. I should have waited until I got the article it before I posted my opinion. The writer is a better communicator than I am.

First of all, you assume that I AM using this way. I have used it a few times in JV ball, not varsity.

You assume that I am sure it is the best. I am not sure it is best.

It seems that a lot of umpires refuse to even consider anything different or new. Generations of baseball umpires got very close to calls at first and usually in foul territory. Just because it has been done one way for a very long time does not make it the best way.

Why can't we have a discussion without people getting surly and insulting?

Trying to call good,

Joe In Michigan

[AtlUmpSteve]

I responded solely on the basis of your responses. You asked, were given 5 immediate negatives. No umpiring sanction, baseball or softball, recommends what you propose for a 60' infield (FYI, even USSSA doesn't use this in a 60' infield, only 65' slowpitch with infielders playing at 80' +), but your response is "there may be negatives, as well...but most of the ones that I hear don't seem to be very well thought out."

In fact, they have been thought out over and over again. Almost every new alphabet soup sanction that springs up want to be different in some way, to be distinctive. Yet, no one has agreed or made that suggestion an approved mechanic. Care to guess why?

You infer that I was getting surly and insulting. In fact, your initial responses disagreeing with every negative stated made set the tone for thread. You insist it is good, despite overwhelming experience and reasons why it isn't. Now who is surly and insulting?

[IRISHMAFIA]

Originally Posted by jwwashburn

It seems that a lot of umpires refuse to even consider anything different or new. Generations of baseball umpires got very close to calls at first and usually in foul territory. Just because it has been done one way for a very long time does not make it the best way.

Why can't we have a discussion without people getting surly and insulting?

Trying to call good,

Joe In Michigan

And yet, you immediately dismissed my responses out of hand. Are you Mr. Pot or Mr. Kettle?

I've worked baseball (22 years). This is my 40th year of umpiring and I've tried quite a few things whether they were in the manual or not.

Personally, from your responses, I have to give Steve's opinion some weight. What makes you think just because you "found" something, that others haven't already been there, done that and are responding to your post with viable experiences? EXPERIENCES, not opinion.

Steve and I teach mechanics. We've learned from some of the best in ASA, and on ocassion, NCAA. What you suggested has been tried, often. It does not work on the small diamond.

[mcrowder]

Originally Posted by jwwashburn

First of all, you assume that I AM using this way. I have used it a few times in JV ball, not varsity. You assume that I am sure it is the best. I am not sure it is best.

Now who is assuming? I assumed nothing of the sort - but simply was offering my advice from the point of view of actually trying out this mechanic.

Originally Posted by jwwashburn

It seems that a lot of umpires refuse to even consider anything different or new. Generations of baseball umpires got very close to calls at first and usually in foul territory. Just because it has been done one way for a very long time does not make it the best way.

True, but generally, in a profession with over 100 years of experience behind it, just about everything has been tried. There are things that change over time, and usually with a reason, and based on actual usage and experience. This mechanic has been used and discarded for the reasons stated above.

Originally Posted by jwwashburn

Why can't we have a discussion without people getting surly and insulting?

Who got surly or insulting? I see nothing surly or insulting. If you find that you cannot digest disagreement with your POV, you will find EVERYONE to be surly and insulting... and then we will actually become surly and insulting.

Originally Posted by jwwashburn

Trying to call good,

Try to call WELL. The only one that should be calling 'good' is the backjudge under the fieldgoal, and Marv Albert.

[CecilOne]

I think we're getting a little testy around here and need to get back to more gentility.

[jwwashburn]

Have any of the people jumping to the conclusion that I am a moron ever considered this mechanic before this thread or, TRIED it out?

Did anyone else see the article?

Again, as I have said, I am not certain it is a better mechanic.

I am certain that I read about it in referee Magazine and I find it worth consideration and discussion.

I am certain that, in person, most umpires I have asked about this also seem to dismiss it without consideration. I am talking about respectful questions with completely dismissive answers-often with less than a hearbeat to respond.

If you look up above, only one poster found any possible positives with this mechanic.

If anything I posted offended anyone, it was not intentional. I was trying to have an actual discussion about this idea. I have about 6 years experience in FP Softball...a LOT less than a lot of the posters here. I learn a lot from a lot of more experienced guys that I have worked with. I am sorry if I gave off an impression that I am not willing to LEARN...Good Grief---If I didn't want to learn, why would I subscribe to Referee and come here?

I am trying to call GOOD because that is what Papa C said in one of his videos.

Joe In Michigan

[Dakota]

Originally Posted by jwwashburn

...don't seem to be very well thought out.

My thoughts, exactly, every time I read one of Mike's posts!