|
|||
glove regs.
Some friends and I are trying to get an answer to the following question...
OBR 1.14 reads in part......The glove shall not measure more than 12" from the tip of any one of the 4 fingers, through the ball pocket to the bottom edge or heel of glove. The glove shall not measure more than 73/4" wide, measured from the inside seam at base of first finger, along base of other fingers, to the outside edge of little finger edge of glove. There is even a diagram (referred to as Diagram #4) Watch any major league game and it will be easy to spot player wearing a glove in excess on 12". Wilson advertises that it's Y. Puig's glove measures 12.75". Is this simply a case of a rule that is no longer followed? |
|
|||
The glove manufacturers claim the measurement is the pattern size - the size of the leather before it gets sewn into a glove.
In reality only outfielders use large gloves. Infielders use smaller gloves to make handling easier and faster. 2B usually uses the smallest - sometimes as small as 10.5"
__________________
Rich Ives Different does not equate to wrong |
|
|||
Quote:
|
|
|||
Quote:
And yes, athe finished size is smaller than the pattern.
__________________
Rich Ives Different does not equate to wrong |
|
|||
From the days when a baseball glove was really a glove:
Babe Ruth's glove, Disney's Mickey Mouse ears among items auctioned in Biddeford - The Portland Press Herald / Maine Sunday Telegram |
|
|||
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NCAA Jump Ball regs | egj13 | Basketball | 1 | Tue Dec 09, 2014 08:04pm |
littlt league pitching regs | MRD | Baseball | 4 | Fri Jul 05, 2013 01:22pm |
Need help with kicking rules and regs | threegunners | Football | 5 | Wed May 29, 2013 10:41pm |
Glove to Glove Contact | Manny A | Softball | 7 | Tue Aug 14, 2012 07:13am |
FED pitching regs | David Emerling | Baseball | 7 | Mon Mar 27, 2006 09:39pm |