![]() |
It depends on the rules your state uses. MD still uses the NFHS visible 10-second count for boys, but DC uses the shot clock to administer the 10-second count. Private schools in my area, at least for boys, also use the shot clock to administer the 10-second count.
|
Quote:
Sent from my SM-N950U using Tapatalk |
Are you talking about the violation known as "over and back", or the 10-second violation? You could have a 10-second violation without player control, but not an "over-and-back" violation.
AFAIK, a player with frontcourt status has to possess the ball, and then either take it into the backcourt, or pass the ball.to a player with backcourt status to trigger that violation. |
Quote:
"Backcourt" violation is the over and back you are referring to. Sent from my SM-N950U using Tapatalk |
Not Intended ...
Quote:
If so, I now "get it". NFHS 2017-18 Basketball Points of Emphasis Team control, throw-in. The relevance of team control during a throw-in only applies when a member of the throw- in team fouls. Such fouls shall be ruled team control fouls. Team control during a throw-in is NOT intended to be the same as player control/team control inbounds. Team control inbounds is established when a player from either team who has inbound status gains control of the ball. During the throw-in, 10-seconds, 3-seconds, frontcourt status, backcourt status, closely guarded, etc., are NOT factors as there has yet to be player control/team control obtained inbounds. |
Yes, the NCAA version of team control starts with the ball being at the disposal of the team for the throw-in, and ends on a change of possession or dead ball. That said, for a backcourt (not a 10-second) violation, player control is required. This is because the ball must first obtain frontcourt status and then achieve backcourt status.
Usually that happens when a player crosses the division line and either retreats back over the division line, or else passes to someone who has not yet crossed the division line. For a 10-second violation, team control, but not player control is required. A common example is when there is a pass with the shot clock at 20 seconds, and the ball is still airborne. That is a 10-second violation. A held ball awarded to the offense with 20 seconds is another example of a 10-second violation without player control, because the offense would be entitled to possession in this scenario, but could not legally put the ball into play without committing a violation. |
Patience Is A Virtue ...
Quote:
|
Quote:
And, you can 't use a 2017-18 POE to apply to a shot clock situation because NFHS didn't have a shot-clock in 2017-18. Obviously that POE would need to be adjusted to reflect that TC DOES apply to 10-second violations when the shot clock is being used. |
Confused ...
Quote:
NFHS: TC starts on possession inbounds (after a temporary/limited initial disposal throwin TC only for foul purposes). NCAA: TC starts on initial disposal TC and continues until it ends (foul, violation, steal, etc.). Quote:
|
[QUOTE=BillyMac;1047171]Now I'm confused again.
NFHS: TC starts on possession inbounds (after a temporary/limited initial disposal throwin TC only for foul purposes). NCAA: TC starts on initial disposal TC and continues until it ends (foul, violation, steal, etc.). Quote:
And, for practical purposes, the definitions and uses of TC are the same in NFHS (when the shot clock is used) and NCAA for TC fouls, BC violations, 10-second violations, 3-second violations, etc. The difference is NFHS with a shot clock and NFHS without a shot clock. |
With/Without ...
Quote:
Fix the ten second rule (touch), or fix the shot clock rule (possession). If the NFHS doesn't fix it, the states will, and then we'll have a hodgepodge of rules. |
All times are GMT -5. The time now is 05:57pm. |