View Single Post
  #14 (permalink)  
Old Sat Jan 21, 2006, 10:06pm
BktBallRef BktBallRef is offline
Official Forum Member
 
Join Date: Aug 2000
Posts: 14,616
Smile

Quote:
Originally posted by blindzebra
Quote:
Originally posted by BktBallRef
I'm going with 5.10.1D on this play, which means all the time would have to be put back on the clock. Since .8 would be less than 1 second, based on 5.10.1D, it would not be possible to put .8 back up.


5.10.1

COMMENT: Timing mistakes which may be corrected are limited to those which result from the timer's neglect to stop or start the clock as specified by the rules. The rules do not permit the referee to correct situations resulting in normal reaction time of the timer which results in a “lag” in stopping the clock. By interpretation, “lag or reaction” time is limited to one second when the official's signal is heard and/or seen clearly. One second or the “reaction” time is interpreted to have elapsed from the time the signal was made until the official glanced at the clock. The additional three seconds which subsequently ran off the clock is considered a timing mistake.

What we do know was that the official saw the request and THEN looked at the clock.

We don't know if the official blew his whistle or not, but if the sequence was TO, whistle, look at clock by rule lag time is interpreted as the time it took the official to look at the clock, so it does not need to be a second.

The one second of lag time is only locked in as one second if the official was looking at the clock at the time the whistle blows, which is what situation D says. That did not happen in this case as written.
Yes, but how do we KNOW that only 1 second ticked off? I don't deny that that's a possibility but the truth is we don't know what happened.
__________________
"...as cool as the other side of the pillow." - Stuart Scott

"You should never be proud of doing the right thing." - Dean Smith
Reply With Quote