Thread: ASA Test #49
View Single Post
  #18 (permalink)  
Old Thu Mar 18, 2010, 11:21am
Dakota Dakota is offline
Official Forum Member
 
Join Date: Sep 2000
Location: Twin Cities MN
Posts: 8,154
Quote:
Originally Posted by MrRabbit View Post
...I have ask around to sources that might know and if they have information on how to call this and have received no replies.
2009 NFHS Case Book

Part 1, Comments on the Rules
BUNT ATTEMPT DEFINITION (2-8-2): The definition of a bunt attempt was changed to require the batter to withdraw the bat in order to take a pitch. Holding the bat in the strike zone without withdrawal will be considered a bunt attempt. The change makes bunt attempts easier for the umpire to determine and creates better balance between offense and defense.

2.8.2 SITUATION: F1 pitches the ball; B1 squares to bunt and (a) leaves the bat in the strike zone without making any movement towards the ball; (b) makes a forward movement with the bat towards the ball; or (c) withdraws the bat prior to the ball entering the plate area. RULING: In (a) and (b), a strike is called on the batter. Holding the bat in the strike zone or making any movement of the bat toward the ball is considered a bunt attempt. In (c), a ball is awarded to the batter; the bat was withdrawn from the plate area. (2-2-1; 2-56-1)

*7.2.1 SITUATION B: (F.P.) B1 starts to swing at a pitch but attempts to hold back, or it appears as though it is an attempt to bunt the ball. In either case, B1 misses the ball. How does the umpire determine what to call the pitch? RULING: A call of this nature is based entirely upon the umpire's judgment. Therefore, the umpire shall, in order to be consistent, have guidelines to follow. Normally there are four areas that constitute whether or not the batter has swung at the ball or checked the swing: (1) rolling the wrist, (2) swinging through the ball and bringing or drawing the bat back, unless drawing it back occurs before the pitch gets to the bat, (3) the bat being out in front of the body, or (4) the batter makes an attempt to hit the pitch. In bunting, any movement of the bat toward the ball when the ball is over or near the plate area, or holding the bat in the strike zone, is a strike. The bat must be withdrawn in order to take a pitch. (2-8-1, 2; 10-1-4 Note)
__________________
Tom
Reply With Quote