Quote:
Originally posted by Camron Rust
Quote:
Originally posted by ChuckElias
I haven't seen a case play on that sitch, but I would say that "you are where you were until you get where you're going" also applies to the ball. So put the ball back in play at the point closest to where the pass was released.
|
Why? Based on your earlier post, it would be where the ball was located when the foul occurs. Why would it be any different if it was not under player control? If the ball is in mid-pass, that's is the spot that will be used to determine the throwin spot.
Scenario: A is down 1 with 5 seconds to go. A inbounds the ball deep in the backcourt to A1 who throws a long pass over a press to a breaking A4. Just before the pass arrives, A4 and B4 commit a double foul (not likely to happen but just assume it does for the sake of the discussion). If you go with a spot near the source of the pass, A will lose the time on the clock for the time that the ball was in the air and also the distance down the floor. I don' think this could be the desired outcome.
|
The only way the clock would be running legally is if the throw-in was after an made basket. Time out, clock stopped; GT or BI, clock stopped; any sort of a spot throw-in, clock stopped.
In the only case of your play, yes, time would run off the clock until the foul was called. But now the clock is stopped for the next throw-in. Does A get the short end of the deal time wise? No. The ensuing inbounds pass is with the clock stopped.
Would A get to run the base line? I don't know.
[Edited by Ref in PA on Sep 27th, 2005 at 12:38 PM]